Enviro EG 40 B Vented Provozní pokyny

SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY THIS MANUAL IS PRINTED ON RECYCLED PAPER EG 40 B Vented By

MAINTENANCE AND TECHNICAL Annually check to ensure that your Vent system is clear. Periodically check the pilot and burner. Check to see that all t

TROUBLE SHOOTING Problem Possible Cause Solution Spark will not light the pilot after repeated pressing of spark Ignitor Defective piezo Ignitor C

GAS LINE CONNECTION ORIFICE SIZES, PRESSURE AND BTU’S NATURAL GAS PROPANE GAS FRONT BURNER #48 (1.93mm) #56 (1.32mm) REAR BURNER #43 (2.49

ELECTRICAL The ENVIRO EG 40.FS.BV. Will operate with no external power supply. These models have a Milli volt gas control valve that uses the pilot f

PARTS AND ACCESSORIES Service Parts available from your local Enviro Dealer Burner Control Assembly Natural Gas Pilot Assembly Propane Pilot Assembl

There is a separate air shutter for each burner. • Remove one screw from the cover plate located below the ash shelf. Loosen the other screw (do not

16 WARRANTY Sherwood Industries Ltd. offers a *Lifetime Warranty on this gas product. The lifetime warranty covers the appliance for a period of sev

17PARTS LIST EC-001 120 ° F (49 °C) Ceramic Temperature Sensor EG40-086 Freestanding Side Panel EC-002 220 °F (104 °C) Ceramic Spill Switch EG40-0

Inner DoorDoor Latch BoltEC-059Door Latch Strip Hinge (Set of 2)EG40-302Glass Extrusions3 Piece Glass Set with GasketComplete Inner Door with GlassEG

Freestanding TopBV EG40-087DV EG40-087AFreestanding Fan MountEG40-304Convection Blower50-514120F (49C) Ceramic Fan Temperature SensorEC-001220 F (104

SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIRO" STOVE, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: GENERAL •

INSTALLATION DATA SHEET The following information must be recorded by the installer for warranty purposes and future reference. Model: EG 40 Name of

3TABLE OF CONTENTS Safety Precautions 2 Code Approvals 3 Deciding where to locate your stove 4Venting 5Installation of Log Sets and Embers 8Ope

DECIDING WHERE TO LOCATE YOUR STOVE DIMENSIONS: FIG. 1 Front Width: 25" (63 cm) Rear Width: 25" (63 cm) Height: 29-1/8" (74 cm*)

VENT TERMINAL CLEARANCES A= Clearance above grade, verandah, porch, deck, or [balcony (*12 inches (30cm) minimum] B= Clearance to win

VENTING This model must have a vent opening in the rear of the unit. Confirm this and also check that the label on the right side panel door states

A. USING AN EXISTING CHIMNEY • Measure the height of the chimney beforehand and purchase the appropriate kit. Never attempt to over stretch a flexi

INSTALLATION OF LOG SET and EMBERS INSTALLING THE GLOWING EMBERS A bag of ceramic fiber embers is provided for use on the front burner ember tray.

OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESU