Enviro Cara Uživatelský manuál stáhnout pdf (Strana 8)

Operating Instructions

For Your Safety, Read Safety Precautions

And Lighting Instructions Before Operating

The ideal ame will be blue at the base and light orange above. The ames should be of medium height.

If the ames look like this (refer to Figure 59 or the Front Cover), no adjustment is needed. If the ames

are fairly short and mostly blue, the replace is getting too much air. Therefore, the air shutter should be

closed slightly until the correct ames are achieved. Flames that are very orange, with tall, dark, stringy

tips, are not getting enough air. Open the air shutter until the ames clean up. If the shutter is opened, or

closed all the way, and the correct ames cannot be attained, turn off the gas and contact the dealer.

Warning: Incorrect air shutter adjustment may lead to improper combustion, which is a safety hazard.

Contact the dealer if there is any concern about the venturi adjustment.

Table 1: Air Shutter Setting Information.

Natural Gas Propane

Amount Air Shutter is Open ¼” (6mm) minimum Completely Open

Remote contRoLs (oPtionaL):

This replace can use an optional remote control or an optional cordless wall thermostat. If either of

these are to be used to control the replace for the majority of the time, leave the ON/OFF switch (on the

rear of the unit) in the “ON” position. Consult the instructions included with the remote/wall thermostat

for operation guidelines. When insalling the Remote Control module, cut out the label along the dotted

line of the Cara Control Panel, and mount the module to the back of the panel using the two (2) provided

Torx T-20 screws and nuts.

bLoweR sPeeD:

For units equipped with blowers, the blower will come on only when the replace is up to temperature

(approximately 12 minutes with unit on high). The blower is equipped with a variable fan controller,

located in the front control panel. This manual control will adjust the fan speed from high to low or turn

the fan off. A remote control for the fan is available through your dealer.

noRmaL sounDs DuRing oPeRation:

Table 2: Normal Sounds

Component Sound & Reason

Cara Creaking when heating up or cooling down.

Burner Light pop or poof when turned off; this is more common with LP units.

Temperature Sensor Clicking when it senses to turn the blower on or off.

Pilot Flame Quiet whisper while the pilot ame is on.

Blower / Fan Air movement that increase and decreases with the speed of the blower.

The blower is pushing the heat from the replace into the room.

Gas Control Valve Dull click when turning on or off, this is the valve opening and closing.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Žádné komentáře

Enviro Cara Uživatelský manuál Strana 8